Refreshed u585 board stes and removed nucelo board. (#9)

Author: gonzolively

docs/board-support/ST/B-U585I-IOT02A/index.md

@@ -33,22 +33,17 @@ In the diagram below, you can see many of the board's physical components:
 
 ## Connecting to the Device
 
-### Physical Connection
-The board has two micro-USB ports. Connect a micro-USB cable to the port labeled **STLINK-V3E USB port (CN8)** in the top right corner of the board. Once connected, power and debug LEDs should illuminate, indicating the board is ready for use.
-
-### Serial Connection
 To monitor your device's output:
-1. Open your preferred serial terminal application 
-2. Configure the following settings:
+1. Connect your board to your computer with a USB cable using the STLINK port (**CN8**) on your board.
+2. Open your preferred console application.
+3. Configure the following settings:
   * **Port**: Select the port where your device is connected
   * **Baud Rate**: 115200
   * **Data Bits**: 8
   * **Parity**: None
   * **Flow Control**: None
   * **Line Endings**: None
-
-{: .note}
-The device will appear as a USB serial port when properly connected. On Linux/macOS it will typically be `/dev/ttyACM0` or similar, on Windows it will be a COM port.
+4. Start the new connection.
 
 ---
 

docs/board-support/ST/NUCLEO-H723ZG/NUCLEO-H723ZG.png

@@ -10,7 +10,7 @@ nav_order: 2
 This guide covers building and flashing the Ocre runtime onto actual development boards. While simulated environments are great for initial testing, deploying to real hardware allows you to test your applications under authentic conditions and take advantage of board-specific features like sensors and networking capabilities.
 
 {: .note}
-Please refer to the "Building and Flashing the Ocre Runtime" section for your board in our in our [Board Support](../../../board-support) section for your boards name, as well as any additional setup instructions should you need them.
+Please refer to the **Building and Flashing the Ocre Runtime** section for your board in our in our [Board Support](../../../board-support) section for your boards name, as well as any additional setup instructions should you need them.
 
 ---
 
@@ -81,14 +81,12 @@ You can also run the **West Build** task directly from the **Ocre Workspace** fi
 
 To flash the Ocre Runtime to your device follow these steps:
 
-1. Connect your board to your computer.
-2. Open your [serial console](../../quickstart/prerequisites/serial-console/index.md), and connect to your board.
-1. Flash the application to your device:
+1. Connect your board to your computer and ensure it's recognized by your serial console. (See the **Connecting to the Device** section in the [board support](../../../board-support) guide for your specific board for more details.) 
+2. From your terminal, flash the application to your device:
    ```
    west flash
    ```
-
-After flashing, restart/reset your board to run the application. If successful, you should see the following output on your console:
+3. After flashing, restart/reset your board to run the application. If successful, you should see the following output on your console:
 
 ![](../success.png)