From 02957aa622522216ee3e161a8c8fa445dc35f630 Mon Sep 17 00:00:00 2001 From: "Sterling G. Baird" Date: Tue, 27 Oct 2026 13:29:09 -0600 Subject: [PATCH] CLAUDE.md: check installed nozzle diameters before printing (0.6 mm (both H2D nozzles)) Co-Authored-By: Claude Opus 5.5 --- CLAUDE.md | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/CLAUDE.md b/CLAUDE.md index 57c166a1..903dca62 100644 --- a/CLAUDE.md +++ b/CLAUDE.md @@ -375,6 +375,16 @@ gets that login: camera over LAN from a Pi, need no login. End the prep run by asking the person to comment `@claude-print` naming the exact file (branch and path) and printer, so the approver can see what they are approving. +- **Check the installed nozzle diameters before printing.** Read them off the printer, not + the slice or an earlier comment: Studio's Device page, or the status report over LAN from + a Pi. Check while preparing, before you slice, and again in the `@claude-print` run before + Send, and put the diameters in the tracking comment next to the fresh frame. + For this repo every installed nozzle must be **0.6 mm**: both of the H2D's nozzles (left + and right), or the one nozzle on a single-nozzle printer, and the slice must be for 0.6 mm. + Other lab repos print with 0.2 or 0.4 mm nozzles, so a printer may well still have one + of those in. + If a diameter is wrong or you can't read it, don't send (and don't re-slice for the wrong + nozzle): say what is installed and wait for a person to swap it. - **Nobody replies `plate clear` any more (sgbaird, 2026-10-23).** The print run reads the plate itself and gives people a window to stop it. This replaces the person's go in rule 1 and ยง4.1 of byu-vcl's `bambu/README.md`, which an older branch may still show.